Open-source syringe extrusion head for shear-thinning materials 3D printing

Abstract

Purpose

This study aims to report the development of an open-source syringe extrusion head for shear-thinning materials. The target is to adapt open-source 3D printers to be helpful in research lines that use gels, hydrogels, pastes, inks, and bio-inks.

Design/methodology/approach

This hardware was designed to be compatible with a Graber i3-based 3D printer; nevertheless, it can be easily adapted to other open-source 3D printers.

Findings

The extrusion head successfully deposits the material during the 3D printing process. It was validated fabricating geometries that include scaffold structures, which are a possible application of bioprinting for tissue engineering. As reported, the extruded filaments allowed the porous samples' structuration.

Practical implications

This system expands the applications of open-source 3D printers used at the laboratory scale. It enables low-cost access to research areas such as tissue engineering and biofabrication, energy storage devices and food 3D printing.

Originality/value

The open-source hardware here reported is of simple fabrication, assembly and installation. It uses a Cardan coupling and a three guides system to transfer the stepper motor motion. This approach allows continuous movement transfer to the syringe piston, producing an adequate deposition or retraction. Thus, the effect of misalignments is avoided, considering that these latter can cause skipping steps in the motor, directly affecting the deposition.

Citation

Dávila, J.L., Manzini, B.M., d'Ávila, M.A. and da Silva, J.V.L. (2022), "Open-source syringe extrusion head for shear-thinning materials 3D printing", Rapid Prototyping Journal, Vol. 28 No. 8, pp. 1452-1461. https://doi.org/10.1108/RPJ-09-2021-0245